Respuesta :
The correct order of configuration commands on switch 2 (SW2) that would allow the network engineer to successfully ping or telnet to SW2 from the management station are:
- Enter IP address of switch 2 (SW2).
- Set IP default-gateway.
- Configure interface VLAN 1.
- No shutdown
What is a command?
A command can be defined as a set of instructions that are typically used to configure a network device such as a switch, so as to make it active on a computer network and enable it perform certain tasks automatically during network communication.
In Computer networking, commands can be used to ensure the interfaces (ports) on a switch are active and open for connections from other network devices such as:
- Routers
- Workstations (computers)
In this scenario, the network engineer should use the following configuration commands on switch 2 (SW2), so as to successfully ping or telnet to SW2 from the management station are:
- Enter IP address of switch 2 (SW2).
- Set IP default-gateway.
- Configure interface VLAN 1.
- No shutdown
Read more on a switch here: https://brainly.com/question/13243868